LaserPecker 4 — Coated Stainless Steel Tumbler

What speed should I use to engrave Coated Stainless Steel Tumbler on the LaserPecker 4?

The top-rated community setting uses 1800 mm/s at 85% power. Use LP4 rotary. App handles rotation speed sync automatically.

Can the LaserPecker 4 cut Coated Stainless Steel Tumbler?

A 2W fiber laser can mark or engrave metal surfaces but cannot cut through them — metal cutting requires a much higher-powered laser or a plasma cutter.

How many passes does the LaserPecker 4 need to engrave Coated Stainless Steel Tumbler?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Coated Stainless Steel Tumbler on the LaserPecker 4?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Coated Stainless Steel Tumbler on the LaserPecker 4?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the LaserPecker 4 for Coated Stainless Steel Tumbler?

The LaserPecker 4 works with LaserPecker. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.