OMTech 40W CO2 — Craft Felt 3mm

What speed should I use to cut Craft Felt 3mm on the OMTech 40W CO2?

The top-rated community setting uses 45 mm/s at 16% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.

How many passes does the OMTech 40W CO2 need to cut Craft Felt 3mm?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Craft Felt 3mm on the OMTech 40W CO2?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Craft Felt 3mm on the OMTech 40W CO2?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the OMTech 40W CO2 for Craft Felt 3mm?

The OMTech 40W CO2 works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.