Ortur Laser Master 3 — Craft Felt 3mm

What speed should I use to cut Craft Felt 3mm on the Ortur Laser Master 3?

The top-rated community setting uses 3000 mm/min at 80% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.

How many passes does the Ortur Laser Master 3 need to cut Craft Felt 3mm?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Craft Felt 3mm on the Ortur Laser Master 3?

Yes — 1 of the 3 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.

What DPI should I use to engrave Craft Felt 3mm on the Ortur Laser Master 3?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the Ortur Laser Master 3 for Craft Felt 3mm?

The Ortur Laser Master 3 works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.