Sculpfun S30 Pro — 3mm Basswood Plywood

What speed should I use to engrave 3mm Basswood Plywood on the Sculpfun S30 Pro?

The top-rated community setting uses 5000 mm/min at 50% power. Fast engrave. Good contrast and detail at 254 DPI.

How many passes does the Sculpfun S30 Pro need to cut 3mm Basswood Plywood?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for 3mm Basswood Plywood on the Sculpfun S30 Pro?

Yes — 2 of the 4 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.

What DPI should I use to engrave 3mm Basswood Plywood on the Sculpfun S30 Pro?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the Sculpfun S30 Pro for 3mm Basswood Plywood?

The Sculpfun S30 Pro works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.