Sculpfun S30 Pro — Coated Stainless Steel Tumbler

What speed should I use to engrave Coated Stainless Steel Tumbler on the Sculpfun S30 Pro?

The top-rated community setting uses 2000 mm/min at 80% power. Higher DPI tumbler pass for fine detail or photo on powder-coated stainless. Rotary required. Keep power moderate.

Can the Sculpfun S30 Pro cut Coated Stainless Steel Tumbler?

A 33W diode laser can mark or engrave metal surfaces but cannot cut through them — metal cutting requires a much higher-powered laser or a plasma cutter.

How many passes does the Sculpfun S30 Pro need to engrave Coated Stainless Steel Tumbler?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Coated Stainless Steel Tumbler on the Sculpfun S30 Pro?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Coated Stainless Steel Tumbler on the Sculpfun S30 Pro?

Settings here use 300–400 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the Sculpfun S30 Pro for Coated Stainless Steel Tumbler?

The Sculpfun S30 Pro works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.