Sculpfun S30 Pro — EVA Foam 3mm

What speed should I use to cut EVA Foam 3mm on the Sculpfun S30 Pro?

The top-rated community setting uses 7000 mm/min at 50% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.

How many passes does the Sculpfun S30 Pro need to cut EVA Foam 3mm?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for EVA Foam 3mm on the Sculpfun S30 Pro?

Yes — 1 of the 3 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.

What DPI should I use to engrave EVA Foam 3mm on the Sculpfun S30 Pro?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the Sculpfun S30 Pro for EVA Foam 3mm?

The Sculpfun S30 Pro works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.