Sculpfun S30 Pro — Powder Coated Steel

What speed should I use to engrave Powder Coated Steel on the Sculpfun S30 Pro?

The top-rated community setting uses 2800 mm/min at 75% power. Ablates powder coat to expose bare metal. Clean with IPA first. Black powder coat gives highest contrast. No Cermark needed.

Can the Sculpfun S30 Pro cut Powder Coated Steel?

A 33W diode laser can mark or engrave metal surfaces but cannot cut through them — metal cutting requires a much higher-powered laser or a plasma cutter.

How many passes does the Sculpfun S30 Pro need to engrave Powder Coated Steel?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Powder Coated Steel on the Sculpfun S30 Pro?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Powder Coated Steel on the Sculpfun S30 Pro?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the Sculpfun S30 Pro for Powder Coated Steel?

The Sculpfun S30 Pro works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.