Sculpfun S30 Pro — Washi Tape
2 community-tested settings for engrave, cut Washi Tape on the Sculpfun S30 Pro. Always run a test on scrap material first.
Where to buy
Buy the Sculpfun S30 Pro — check current price & availability
Affiliate link — we may earn a small commission at no extra cost to you.
These 2 settings cover engrave and cut Washi Tape on the Sculpfun S30 Pro (33W diode laser). Keep speeds high and power low to avoid burning through; masking tape on the surface reduces scorching around cut edges.
2 settings
Frequently asked questions
What speed should I use to engrave Washi Tape on the Sculpfun S30 Pro?
The top-rated community setting uses 4500 mm/min at 9% power. Very low power to avoid burning through — washi tape is thin. No air assist. Pin sheet flat.
How many passes does the Sculpfun S30 Pro need to cut Washi Tape?
All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.
Do I need air assist for Washi Tape on the Sculpfun S30 Pro?
Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.
What DPI should I use to engrave Washi Tape on the Sculpfun S30 Pro?
Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.
What software do I use with the Sculpfun S30 Pro for Washi Tape?
The Sculpfun S30 Pro works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.
Now make something with Washi Tape
Templates ready to cut on your Sculpfun S30 Pro once you've dialed in the settings.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris