Sculpfun S9 — Marble Tile

What speed should I use to engrave Marble Tile on the Sculpfun S9?

The top-rated community setting uses 1500 mm/min at 80% power. Higher speed with full power for faster throughput on marble tile engravings.

Can the Sculpfun S9 cut Marble Tile?

Cutting Marble Tile on the Sculpfun S9 may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the Sculpfun S9 need to engrave Marble Tile?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Marble Tile on the Sculpfun S9?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Marble Tile on the Sculpfun S9?

Settings here use 254–400 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the Sculpfun S9 for Marble Tile?

The Sculpfun S9 works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.