Snapmaker Ray 20W: HDPE (Cutting Board)

What speed should I use to engrave HDPE (Cutting Board) on the Snapmaker Ray 20W?

The top-rated community setting uses 2800 mm/min at 50% power. Engrave only -- HDPE melts and gums up rather than cutting cleanly, leaving a rough, melted kerf. Not toxic, just a poor cut; use a router/CNC if you need it cut.

Can the Snapmaker Ray 20W cut HDPE (Cutting Board)?

Cutting HDPE (Cutting Board) on the Snapmaker Ray 20W may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the Snapmaker Ray 20W need to engrave HDPE (Cutting Board)?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for HDPE (Cutting Board) on the Snapmaker Ray 20W?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.