Snapmaker Ray 20W: Polycarbonate (Lexan)

What speed should I use to engrave Polycarbonate (Lexan) on the Snapmaker Ray 20W?

The top-rated community setting uses 4000 mm/min at 30% power. Engrave only -- polycarbonate scorches, yellows, and can craze/crack if you try to cut it with a CO2 or diode laser. Low power, high speed, single pass.

Can the Snapmaker Ray 20W cut Polycarbonate (Lexan)?

Cutting Polycarbonate (Lexan) on the Snapmaker Ray 20W may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the Snapmaker Ray 20W need to engrave Polycarbonate (Lexan)?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Polycarbonate (Lexan) on the Snapmaker Ray 20W?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.