Snapmaker Ray 20W — Rubber Stamp Material
1 community-tested setting for engrave Rubber Stamp Material on the Snapmaker Ray 20W. Always run a test on scrap material first.
These 1 setting cover engrave Rubber Stamp Material on the Snapmaker Ray 20W (20W diode laser). Always test on scrap before committing to your final piece — material batches can vary in density and composition.
1 setting
Frequently asked questions
What speed should I use to engrave Rubber Stamp Material on the Snapmaker Ray 20W?
The top-rated community setting uses 2000 mm/min at 55% power. Invert design for stamp relief.
Can the Snapmaker Ray 20W cut Rubber Stamp Material?
Cutting Rubber Stamp Material on the Snapmaker Ray 20W may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.
How many passes does the Snapmaker Ray 20W need to engrave Rubber Stamp Material?
All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.
Do I need air assist for Rubber Stamp Material on the Snapmaker Ray 20W?
Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.
What DPI should I use to engrave Rubber Stamp Material on the Snapmaker Ray 20W?
Settings here use 500 DPI. Higher DPI gives finer detail but significantly increases burn time — 300 DPI is a good balance for most projects.
Now make something with Rubber Stamp Material
Templates ready to cut on your Snapmaker Ray 20W once you've dialed in the settings.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris