Trotec Speedy 300 — Plywood
2 community-tested settings for engrave, cut Plywood on the Trotec Speedy 300. Always run a test on scrap material first.
These 2 settings cover engrave and cut Plywood on the Trotec Speedy 300 (60W CO₂ laser). Wood results vary by grain direction and moisture content — always run a quick test on scrap before cutting your final piece.
2 settings
Frequently asked questions
What speed should I use to engrave Plywood on the Trotec Speedy 300?
The top-rated community setting uses 400 mm/s at 20% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.
How many passes does the Trotec Speedy 300 need to cut Plywood?
All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.
Do I need air assist for Plywood on the Trotec Speedy 300?
Yes — 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.
What DPI should I use to engrave Plywood on the Trotec Speedy 300?
Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.
Now make something with Plywood
Templates ready to cut on your Trotec Speedy 300 once you've dialed in the settings.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris