xTool F1 Ultra (UV) — Genuine Leather

What speed should I use to engrave Genuine Leather on the xTool F1 Ultra (UV)?

The top-rated community setting uses 500 mm/s at 30% power. UV engraves leather without burning smell. Clean edge detail.

Can the xTool F1 Ultra (UV) cut Genuine Leather?

Cutting Genuine Leather on the xTool F1 Ultra (UV) may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the xTool F1 Ultra (UV) need to engrave Genuine Leather?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Genuine Leather on the xTool F1 Ultra (UV)?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Genuine Leather on the xTool F1 Ultra (UV)?

Settings here use 500 DPI. Higher DPI gives finer detail but significantly increases burn time — 300 DPI is a good balance for most projects.

What software do I use with the xTool F1 Ultra (UV) for Genuine Leather?

The xTool F1 Ultra (UV) works with xTool Creative Space and LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.