xTool P2 — 3mm Maple Plywood

What speed should I use to engrave 3mm Maple Plywood on the xTool P2?

The top-rated community setting uses 410 mm/min at null% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.

How many passes does the xTool P2 need to engrave 3mm Maple Plywood?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for 3mm Maple Plywood on the xTool P2?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave 3mm Maple Plywood on the xTool P2?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool P2 for 3mm Maple Plywood?

The xTool P2 works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.