xTool P2 — Cardstock

What speed should I use to cut Cardstock on the xTool P2?

The top-rated community setting uses 150 mm/s at 10% power. Cardstock on xTool P2. Clean single pass with low power.

How many passes does the xTool P2 need to cut Cardstock?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Cardstock on the xTool P2?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Cardstock on the xTool P2?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool P2 for Cardstock?

The xTool P2 works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.