xTool P2: Rowmark Engraving Plastic

What speed should I use to score Rowmark Engraving Plastic on the xTool P2?

The top-rated community setting uses 300 mm/s at 10% power. Vector score to remove the top color layer only -- do not cut through. Remove masking film first.

How many passes does the xTool P2 need to engrave Rowmark Engraving Plastic?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Rowmark Engraving Plastic on the xTool P2?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What software do I use with the xTool P2 for Rowmark Engraving Plastic?

The xTool P2 works with xTool Studio and xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings: no conversion needed.