xTool P2 — Rubber Stamp Blank

What speed should I use to cut Rubber Stamp Blank on the xTool P2?

The top-rated community setting uses 15 mm/s at 50% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.

How many passes does the xTool P2 need to cut Rubber Stamp Blank?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Rubber Stamp Blank on the xTool P2?

Yes — 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.

What DPI should I use to engrave Rubber Stamp Blank on the xTool P2?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool P2 for Rubber Stamp Blank?

The xTool P2 works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.