xTool P2 — Stainless Steel

What speed should I use to engrave Stainless Steel on the xTool P2?

The top-rated community setting uses 275 mm/s at 52% power. CO2 60W on stainless with marking spray.

Can the xTool P2 cut Stainless Steel?

A 55W CO₂ laser can mark or engrave metal surfaces but cannot cut through them — metal cutting requires a much higher-powered laser or a plasma cutter.

How many passes does the xTool P2 need to engrave Stainless Steel?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Stainless Steel on the xTool P2?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Stainless Steel on the xTool P2?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool P2 for Stainless Steel?

The xTool P2 works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.