xTool S1 40W — Anodized Aluminum

What speed should I use to engrave Anodized Aluminum on the xTool S1 40W?

The top-rated community setting uses 3000 mm/min at 70% power. Ablates anodizing to reveal bare aluminum. Clean with IPA first. Black anodized gives highest contrast.

Can the xTool S1 40W cut Anodized Aluminum?

A 40W diode laser can mark or engrave metal surfaces but cannot cut through them — metal cutting requires a much higher-powered laser or a plasma cutter.

How many passes does the xTool S1 40W need to engrave Anodized Aluminum?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Anodized Aluminum on the xTool S1 40W?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Anodized Aluminum on the xTool S1 40W?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool S1 40W for Anodized Aluminum?

The xTool S1 40W works with xTool Creative Space and LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.