xTool S1 40W — Cork 3mm

What speed should I use to cut Cork 3mm on the xTool S1 40W?

The top-rated community setting uses 1200 mm/min at 80% power. Single pass. Cork cuts cleanly — use masking to keep surface clean.

How many passes does the xTool S1 40W need to cut Cork 3mm?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Cork 3mm on the xTool S1 40W?

Yes — 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.

What DPI should I use to engrave Cork 3mm on the xTool S1 40W?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool S1 40W for Cork 3mm?

The xTool S1 40W works with xTool Creative Space and LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.