xTool S1 40W — Faux Leather

What speed should I use to cut Faux Leather on the xTool S1 40W?

The top-rated community setting uses 900 mm/min at 90% power. Cuts cleanly. Air assist prevents edge melting.

How many passes does the xTool S1 40W need to cut Faux Leather?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Faux Leather on the xTool S1 40W?

Yes — 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.

What DPI should I use to engrave Faux Leather on the xTool S1 40W?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool S1 40W for Faux Leather?

The xTool S1 40W works with xTool Creative Space and LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.