xTool S1 40W: HDPE (Cutting Board)

What speed should I use to engrave HDPE (Cutting Board) on the xTool S1 40W?

The top-rated community setting uses 7200 mm/min at 38% power. Engrave only -- HDPE melts and gums up rather than cutting cleanly, leaving a rough, melted kerf. Not toxic, just a poor cut; use a router/CNC if you need it cut.

Can the xTool S1 40W cut HDPE (Cutting Board)?

Cutting HDPE (Cutting Board) on the xTool S1 40W may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the xTool S1 40W need to engrave HDPE (Cutting Board)?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for HDPE (Cutting Board) on the xTool S1 40W?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What software do I use with the xTool S1 40W for HDPE (Cutting Board)?

The xTool S1 40W works with LightBurn and xTool Studio and xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings: no conversion needed.