xTool S1 40W — Pine 3mm

What speed should I use to engrave Pine 3mm on the xTool S1 40W?

The top-rated community setting uses 5000 mm/min at 65% power. Pine grain gives natural variation in burn depth. Test across grain.

How many passes does the xTool S1 40W need to cut Pine 3mm?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Pine 3mm on the xTool S1 40W?

Yes — 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.

What DPI should I use to engrave Pine 3mm on the xTool S1 40W?

Settings here use 254 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool S1 40W for Pine 3mm?

The xTool S1 40W works with xTool Creative Space and LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.