xTool S1 40W — Slate

What speed should I use to engrave Slate on the xTool S1 40W?

The top-rated community setting uses 3000 mm/min at 80% power. Fractures surface to reveal lighter material beneath. Invert image — engraved areas appear lighter.

Can the xTool S1 40W cut Slate?

Cutting Slate on the xTool S1 40W may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the xTool S1 40W need to engrave Slate?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Slate on the xTool S1 40W?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Slate on the xTool S1 40W?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool S1 40W for Slate?

The xTool S1 40W works with xTool Creative Space and LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.