xTool S1 — Photopolymer Stamp Blank

What speed should I use to engrave Photopolymer Stamp Blank on the xTool S1?

The top-rated community setting uses 3000 mm/min at 55% power. 500 DPI gives finer stamp detail. Deeper engrave = higher relief = crisper impression. Always test on scrap first.

Can the xTool S1 cut Photopolymer Stamp Blank?

Cutting Photopolymer Stamp Blank on the xTool S1 may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the xTool S1 need to engrave Photopolymer Stamp Blank?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Photopolymer Stamp Blank on the xTool S1?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Photopolymer Stamp Blank on the xTool S1?

Settings here use 500 DPI. Higher DPI gives finer detail but significantly increases burn time — 300 DPI is a good balance for most projects.

What software do I use with the xTool S1 for Photopolymer Stamp Blank?

The xTool S1 works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.