xTool S1 — Slate (coaster)

What speed should I use to engrave Slate (coaster) on the xTool S1?

The top-rated community setting uses 2200 mm/min at 90% power. Higher DPI for fine detail and photo work on slate coasters.

Can the xTool S1 cut Slate (coaster)?

Cutting Slate (coaster) on the xTool S1 may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the xTool S1 need to engrave Slate (coaster)?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Slate (coaster) on the xTool S1?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Slate (coaster) on the xTool S1?

Settings here use 300–400 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the xTool S1 for Slate (coaster)?

The xTool S1 works with xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.