Acrylic 6mm
This page lists 4 community-tested settings for Acrylic 6mm. Acrylic cuts and engraves cleanly on both CO2 and diode lasers. Cast acrylic gives a frosted edge on cuts; extruded acrylic melts and polishes.
Top setting per machine
Works with these machines
4 settings
Supplies to have on hand
Materials and accessories that pair well with Acrylic 6mm laser projects.
Frequently Asked Questions
What are the best laser settings for Acrylic 6mm?
A top-rated community setting for Acrylic 6mm on the OMTech 80W CO2 is speed 300 mm/s, power 10–15%. There are 4 community-tested settings for Acrylic 6mm across 2 machines on this page.
Do I need air assist for Acrylic 6mm?
50% of the community settings for Acrylic 6mm use air assist. Air assist is strongly recommended - it reduces charring and improves cut quality.
What speed and power to cut Acrylic 6mm in one pass?
Settings vary by machine wattage. For a 20W diode laser, cutting Acrylic 6mm typically requires high power (90–100%) at moderate speed (1500–3000 mm/min) with air assist. CO₂ lasers can cut 6mm material faster - 20–60 mm/s at 50–70% power is common. Check the settings table below for your specific machine.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris