OMTech 60W CO2 — Ceramic Mug

What speed should I use to engrave Ceramic Mug on the OMTech 60W CO2?

The top-rated community setting uses 300 mm/s at 55% power. Apply Cermark spray to mug surface, let dry 10 minutes. Laser with rotary attachment. Wash off Cermark with water — permanent black fused mark remains. Allow 24 hours before dishwasher use.

Can the OMTech 60W CO2 cut Ceramic Mug?

Cutting Ceramic Mug on the OMTech 60W CO2 may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the OMTech 60W CO2 need to engrave Ceramic Mug?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Ceramic Mug on the OMTech 60W CO2?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Ceramic Mug on the OMTech 60W CO2?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.

What software do I use with the OMTech 60W CO2 for Ceramic Mug?

The OMTech 60W CO2 works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.