Sculpfun S30 Pro — Photopolymer Stamp Blank

What speed should I use to engrave Photopolymer Stamp Blank on the Sculpfun S30 Pro?

The top-rated community setting uses 2500 mm/min at 60% power. 500 DPI gives finer stamp detail. Deeper engrave = higher relief = crisper impression. Always test on scrap first.

Can the Sculpfun S30 Pro cut Photopolymer Stamp Blank?

Cutting Photopolymer Stamp Blank on the Sculpfun S30 Pro may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the Sculpfun S30 Pro need to engrave Photopolymer Stamp Blank?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Photopolymer Stamp Blank on the Sculpfun S30 Pro?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Photopolymer Stamp Blank on the Sculpfun S30 Pro?

Settings here use 500 DPI. Higher DPI gives finer detail but significantly increases burn time — 300 DPI is a good balance for most projects.

What software do I use with the Sculpfun S30 Pro for Photopolymer Stamp Blank?

The Sculpfun S30 Pro works with LightBurn. Enter the speed, power, and passes directly into your software's layer settings — no conversion needed.