Trotec Speedy 300 — Leather
2 community-tested settings for cut, engrave Leather on the Trotec Speedy 300. Always run a test on scrap material first.
These 2 settings cover cut and engrave Leather on the Trotec Speedy 300 (60W CO₂ laser). Genuine leather tolerates lower power than faux leather; go slowly and increase passes rather than power to avoid scorching. Some settings use multiple passes for a cleaner cut — pin or tape your material flat before running to prevent shift between passes.
2 settings
Frequently asked questions
What speed should I use to cut Leather on the Trotec Speedy 300?
The top-rated community setting uses 300 mm/min at 65% power, 2 passes. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.
How many passes does the Trotec Speedy 300 need to cut Leather?
Settings here range from 1 to 2 passes. Multiple passes give a cleaner edge but increase the risk of material shift — always pin or tape your material flat before running.
Do I need air assist for Leather on the Trotec Speedy 300?
Yes — 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.
Now make something with Leather
Templates ready to cut on your Trotec Speedy 300 once you've dialed in the settings.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris