Leather

80W can overburn leather quickly. Start at 15% and test before full run.

5W Falcon engraves leather. Ventilate well.

20W Atomstack cuts leather in 2 passes at full power.

Leather cuts in one pass on 100W Boss. Moderate power to prevent edge char.

Leather cuts cleanly on 80W in one pass at moderate power.

0

K40 cuts leather well at 65%. One pass for up to 3mm thickness.

Glowforge Pro cuts vegetable-tanned leather cleanly in one pass.

20W diode cuts leather in 2 passes. Ventilate well — leather fumes are strong.

P2 cuts leather easily — lower power than wood to avoid burning edges.

60W CO2 cuts leather cleanly in one pass. Keep power moderate to avoid charring edges.

22W B1 cuts leather in 2 passes at full power. Air assist helps keep edges clean.

40W S1 cuts leather in 2 passes at 90%. Only use vegetable-tanned leather — chrome-tanned is toxic.

Cut vegetable-tanned leather at full power 2 passes. Faux/chrome-tanned leather produces toxic fumes — avoid.

Leather engraving at moderate speed and power on B1.

0

Engrave leather at moderate power. Ventilate well.

0

0

Engrave leather at 50% — 22W is powerful enough to burn through at higher settings.

Vegetable-tanned leather engraves beautifully. Avoid chrome-tanned — produces harmful fumes.

Engrave at moderate power. Ventilate well — leather produces strong fumes.

M1 enclosed design makes leather engraving much more pleasant — no smoke smell. Same settings as D1 Pro.

Good leather engrave on Sculpfun. Slightly larger spot than xTool means detail is marginally less sharp at same DPI.

Suede is delicate — very easy to over-burn. Start lower than you think. Result depends heavily on suede quality and thickness. Always test.

Similar settings to xTool. Ortur can run slightly hotter so start 5% lower than you would on xTool.

Single pass clean cut. Glowforge has great leather cutting results. Keep masking on surface to prevent smoke marks.

Single pass clean cut on veg tan with CO2. Sealed edges, slight char is normal and can be burnished off.

2 passes cuts cleanly through 2-3mm veg tan. Seal edges with edge paint or beeswax after cutting for a professional finish.

CO2 cuts leather beautifully with sealed edges. Slightly charred edge is normal on veg tan — wipe with damp cloth.

5W needs more power than 10W equivalent. Good clean result. Tape leather flat before engraving — any curl will throw off focus.

Glowforge speed is scaled 1-1000. Approx 170mm/s at setting 500. Vary power 20-40% for lighter/darker.

What are the best laser settings for Leather?

A top-rated community setting for Leather on the OMTech 80W CO2 is speed 350 mm/s, power 15%. There are 96 community-tested settings for Leather across 50 machines on this page.

Can a diode laser engrave or cut Leather?

Yes — there are 56 community settings for Leather on diode lasers and 40 on CO₂ lasers. CO₂ lasers generally cut faster and cleaner, but modern high-wattage diode lasers handle most leather work well.

Do I need air assist for Leather?

55% of the community settings for Leather use air assist. Air assist is strongly recommended — it reduces charring and improves cut quality.