Trotec Speedy 300 — Marble Tile

What speed should I use to engrave Marble Tile on the Trotec Speedy 300?

The top-rated community setting uses 108 mm/s at 44% power. Always run a test burn on scrap material first to confirm focus and power are correct for your specific batch.

Can the Trotec Speedy 300 cut Marble Tile?

Cutting Marble Tile on the Trotec Speedy 300 may be possible but no verified cut settings have been submitted yet. You can contribute your own tested settings using the button above.

How many passes does the Trotec Speedy 300 need to engrave Marble Tile?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Marble Tile on the Trotec Speedy 300?

Air assist is not flagged as required for these settings, but it is good practice during cutting operations to keep the lens clean and reduce char buildup.

What DPI should I use to engrave Marble Tile on the Trotec Speedy 300?

Settings here use 300 DPI. For photographic detail or fine artwork, consider testing at higher DPI, but expect longer run times.