xTool S1 40W: Polypropylene (Coroplast)

What speed should I use to cut Polypropylene (Coroplast) on the xTool S1 40W?

The top-rated community setting uses 800 mm/min at 65% power. Air assist strongly recommended to clear melted plastic and keep the flutes from re-fusing. Typical corrugated board is ~4mm.

How many passes does the xTool S1 40W need to cut Polypropylene (Coroplast)?

All settings here use a single pass. Confirm focus and do a small test burn before committing to your final design.

Do I need air assist for Polypropylene (Coroplast) on the xTool S1 40W?

Yes: 1 of the 2 settings here specify air assist on. It clears smoke and debris from the cut line, improves edge quality, and reduces fire risk especially during cutting.

What software do I use with the xTool S1 40W for Polypropylene (Coroplast)?

The xTool S1 40W works with LightBurn and xTool Studio and xTool Creative Space. Enter the speed, power, and passes directly into your software's layer settings: no conversion needed.