Silver Jewellery

Gentle on silver jewellery. 2W is well-suited for fine pieces.

Delicate mark. 2W is actually safer on jewellery than higher wattage.

Fine detail on silver. MOPA keeps heat low for intricate designs.

Reduce power at 30W — silver is delicate. Test first.

Delicate mark on silver. Low power to avoid melting fine detail.

Sterling silver marks with a subtle dark oxidised finish. The LP4's portability makes it useful for hallmarking and personalising at craft fairs and jewellery exhibitions without needing a fixed studio setup. Always test on scrap silver first.

Sterling silver marks with a dark oxidised surface. Test power carefully — fine jewellery pieces need lower power to avoid overheating thin sections. At 40% you get a clear mark without distorting thin wire settings.

Surface mark on sterling silver. 50% power gives visible dark mark. Test on scrap piece first.

What are the best laser settings for Silver Jewellery?

A top-rated community setting for Silver Jewellery on the LaserPecker 4 is speed 2000 mm/s, power 70%. There are 10 community-tested settings for Silver Jewellery across 6 machines on this page.

Do I need a fiber laser for Silver Jewellery?

Fiber lasers can mark Silver Jewellery directly without any coating. There are 10 fiber laser settings on this page. Diode and CO₂ lasers may require a marking compound (like Cermark) to achieve a visible result on bare metal.