Monport EffI10S 100W CO2 Settings & Speeds

What materials can the Monport EffI10S 100W CO2 engrave or cut?

The Monport EffI10S 100W CO2 has community-tested settings for Leather, Plywood, Cork, Bamboo, Cardboard, 3mm MDF, Genuine Leather, 3mm Baltic Birch Plywood, and 27 more. Results vary by material batch, focus, and ambient conditions: always test on scrap first.

What settings should I use to cut Bamboo on the Monport EffI10S 100W CO2?

A community-tested starting point is speed 300 mm/min, power 55–60% in 2 passes. Enable air assist for a cleaner edge. Always run a test cut on scrap to confirm before committing to your project.

What can a CO₂ laser like the Monport EffI10S 100W CO2 cut that a diode laser cannot?

CO₂ lasers can cut and engrave clear acrylic, glass (with care), fabric, and thicker wood more cleanly than diode lasers, because the CO₂ wavelength is absorbed by materials that are transparent to diode light. This makes the Monport EffI10S 100W CO2 more versatile for craft and production use.