6mm Basswood Plywood

6mm basswood in one pass — a key advantage of the 33W module over standard 20W diodes. Focus at the top surface. Built-in air assist prevents the deep kerf from igniting. Clean cuts with minimal char compared to running multiple passes on lower-power machines.

6mm basswood in one pass — 22W handles this but it's near the machine's limits. Focus carefully at the top surface. Air assist is essential. Edges have slightly more char than 3mm cuts. If you regularly cut 6mm, consider the S30 Pro's 33W for cleaner results.

6mm basswood in one pass — this is the S30 Pro's headline capability. Air assist is built in and essential for this cut depth. Focus carefully at the top surface. A significant advantage over 20W diodes which need 3-4 passes for the same material.

3 passes needed for 6mm basswood at 20W — this is pushing the LM3's limits. Results are usable but edges have significant char. If you regularly cut 6mm wood, a CO2 laser or higher-wattage diode is a better choice. Air assist is essential to prevent fire between passes.

6mm basswood in one pass — the 60W tube handles this with ease. The Nova 35's Z-table lifts to accommodate thicker material and maintains consistent focus throughout the cut. Air assist is integrated and essential for keeping the kerf clean on thick material.

6mm basswood in one pass — the 40W module handles this cleanly. Increase focus depth to the centre of the material (3mm). Air assist prevents flareup inside the deep kerf. Consistent results across the full sheet with the S1's enclosed design.

Deeper relief at 6mm thickness. Good for signs and layered designs.

6mm basswood needs 2 passes. Refocus between passes for best edge quality.

What are the best laser settings for 6mm Basswood Plywood?

A top-rated community setting for 6mm Basswood Plywood on the ACMER P2 33W is speed 2000 mm/min, power 35–40%. There are 14 community-tested settings for 6mm Basswood Plywood across 7 machines on this page.

Can a diode laser engrave or cut 6mm Basswood Plywood?

Yes - there are 10 community settings for 6mm Basswood Plywood on diode lasers and 4 on CO₂ lasers. CO₂ lasers generally cut faster and cleaner, but modern high-wattage diode lasers handle most wood work well.

Do I need air assist for 6mm Basswood Plywood?

50% of the community settings for 6mm Basswood Plywood use air assist. Air assist is strongly recommended - it reduces charring and improves cut quality.

What speed and power to cut 6mm Basswood Plywood in one pass?

Settings vary by machine wattage. For a 20W diode laser, cutting 6mm Basswood Plywood typically requires high power (90–100%) at moderate speed (1500–3000 mm/min) with air assist. CO₂ lasers can cut 6mm material faster - 20–60 mm/s at 50–70% power is common. Check the settings table below for your specific machine.