FLUX Ador Settings & Speeds
Updated May 2026 · 64 tested settings · 38 materials
Free download
📧 Email me the FLUX Ador cheat sheet (PDF)
Printable one-pager with the most-used speed/power/passes. Plus 10% off your first order.
We'll only email about new settings + occasional new releases. Unsubscribe anytime.
The FLUX Ador is a 50W co2 laser engraver with a 600×375mm work area. This page lists 64 community-tested settings covering speed, power, passes, air assist, and DPI across a range of materials. Always run a test cut on scrap material first — results vary depending on your material batch, focus, and ambient conditions.
The FLUX Ador is an enclosed diode laser from FLUX, the company behind the Beamo CO₂ machine. It uses Beam Studio software with some LightBurn compatibility and features a camera for material alignment. Best for wood, leather, light acrylic engraving, and light cutting. A beginner-friendly enclosed machine for home studios that value safety and ease of use.
Similar machines
Materials covered
Don't see your material?
64 settings
From the Blog
Frequently Asked Questions
What materials can the FLUX Ador engrave or cut?
The FLUX Ador has community-tested settings for 3mm Mirrored Acrylic, 3mm Clear Acrylic (Cast), 3mm Maple Plywood, Stainless Steel, Marble Tile, Rubber Stamp Material, 6mm MDF, 6mm Baltic Birch Plywood, and 30 more. Results vary by material batch, focus, and ambient conditions — always test on scrap first.
What is the work area of the FLUX Ador?
The FLUX Ador has a work area of 600×375 mm (approximately 24×15 inches).
What settings should I use to cut Rubber Stamp Material on the FLUX Ador?
A community-tested starting point is speed 10 mm/s, power 82% in a single pass. Always run a test cut on scrap to confirm before committing to your project.
What can a CO₂ laser like the FLUX Ador cut that a diode laser cannot?
CO₂ lasers can cut and engrave clear acrylic, glass (with care), fabric, and thicker wood more cleanly than diode lasers, because the CO₂ wavelength is absorbed by materials that are transparent to diode light. This makes the FLUX Ador more versatile for craft and production use.
Compare with similar machines
Same laser type · similar wattage
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris