Thunder Laser Nova 24 Settings & Speeds

Consistent with the 55-60W CO2 baseline used across the settings database.

Consistent with the 55-60W CO2 baseline used across the settings database.

Consistent with the 55-60W CO2 baseline used across the settings database.

Consistent with the 55-60W CO2 baseline used across the settings database.

Consistent with the 55-60W CO2 baseline used across the settings database.

Consistent with the 55-60W CO2 baseline used across the settings database.

Consistent with the 55-60W CO2 baseline used across the settings database.

Consistent with the 55-60W CO2 baseline used across the settings database.

Consistent with the 55-60W CO2 baseline used across the settings database (OMTech 60W CO2, Gweike Cloud Pro II 55W).

What materials can the Thunder Laser Nova 24 engrave or cut?

The Thunder Laser Nova 24 has community-tested settings for Slate, Genuine Leather, 3mm MDF, 3mm Clear Acrylic, 3mm Basswood Plywood. Results vary by material batch, focus, and ambient conditions: always test on scrap first.

Is the Thunder Laser Nova 24 compatible with LightBurn?

Yes, the Thunder Laser Nova 24 works natively with LightBurn.

What is the work area of the Thunder Laser Nova 24?

The Thunder Laser Nova 24 has a work area of 600×400 mm (approximately 24×16 inches).

What settings should I use to cut Genuine Leather on the Thunder Laser Nova 24?

A community-tested starting point is speed 14 mm/s, power 60–65% in a single pass. Enable air assist for a cleaner edge. Always run a test cut on scrap to confirm before committing to your project.

What can a CO₂ laser like the Thunder Laser Nova 24 cut that a diode laser cannot?

CO₂ lasers can cut and engrave clear acrylic, glass (with care), fabric, and thicker wood more cleanly than diode lasers, because the CO₂ wavelength is absorbed by materials that are transparent to diode light. This makes the Thunder Laser Nova 24 more versatile for craft and production use.