Cardstock 300gsm
This page lists 46 community-tested settings for Cardstock 300gsm. Paper cuts cleanly on both diode and CO₂ lasers - the key is high speed and low power to avoid charring and burning. Thinner paper (80gsm) needs less power than cardstock (200–300gsm). Air assist is usually not needed and can cause tearing on lightweight sheets.
Top setting per machine
Showing top 12 of 19 machines. See full list below.
Works with these machines
46 settings
Supplies to have on hand
Materials and accessories that pair well with Cardstock 300gsm laser projects.
Frequently Asked Questions
What are the best laser settings for Cardstock 300gsm?
A top-rated community setting for Cardstock 300gsm on the ComMarker B6 20W UV is speed 400 mm/s, power 50%. There are 46 community-tested settings for Cardstock 300gsm across 19 machines on this page.
Can a diode laser engrave or cut Cardstock 300gsm?
Yes - there are 24 community settings for Cardstock 300gsm on diode lasers and 20 on CO₂ lasers. CO₂ lasers generally cut faster and cleaner, but modern high-wattage diode lasers handle most paper work well.
Laser cutting paper - what you need to know
Paper is one of the easiest materials to laser cut, but getting clean edges without charring takes the right balance of speed and power. The golden rule: go fast, go light. A 40W CO₂ laser cutting 80gsm copy paper might run at 120 mm/s and only 9% power - barely anything. Diode lasers need a bit more power but the same principle applies.
Paper vs cardstock laser settings
Lightweight copy paper (75–90gsm) needs the least power and highest speed. Medium cardstock (160–200gsm) can handle slightly more power. Heavy cardstock and chipboard (250–350gsm) may need 2 passes or a modest power increase. The settings in the table above cover this range across the most popular machines.
Tips for cleaner paper cuts
- Turn off air assist - it blows lightweight paper off the bed
- Use a honeycomb or pin bed to support the sheet flat
- Tape the corners to prevent lifting mid-cut
- For intricate designs, reduce speed by 10–15% and power by the same - this gives the laser more time to cut cleanly without burning
- If you get consistent char on one side, check your lens focus
Related materials
See also: Cardstock 300gsm, Kraft Paper, Foam Board, Corrugated Cardboard.
Some links on this page are affiliate links. We may earn a small commission at no extra cost to you.
"Used it with a Glowforge — engraved beautifully with no changes. I will be purchasing more digital downloads from this shop."
— Anna
"I was struggling with lining up my NFC business cards. I was able to not only line them up much better but also do multiple cards at once — making that job so much easier."
— Camp
"Excellent quality and design. Cut clean and neat!"
— LYNN
"Great jigs. Appreciate the time saved not having to build this from scratch!"
— Bruce
"Excellent quality. Item as described. Expectations exceeded."
— Michael
"This template made my slate coasters so much easier. 4×4 coasters from Michaels drop in easily and are easy to remove. Def worth it."
— chris